CodeChart:HP 2648A/HP 2648 Mode

From Terminals
< CodeChart:HP 2648A
Revision as of 17:17, 15 February 2013 by Legalize (talk | contribs) (moved User:Legalize/Control Sequences/HP 2648A/HP 2648 Mode to CodeChart:HP 2648A/HP 2648 Mode: Promote to real code chart)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Subpages of HP 2648 Mode

Received
0 1 2 3 4 5 6 7
0 NUL DLE SP 0 @ P ` p
1 SOH DC1 ! 1 A Q a q
2 STX DC2 " 2 B R b r
3 ETX DC3 # 3 C S c s
4 EOT DC4 $ 4 D T d t
5 ENQ NAQ % 5 E U e u
6 ACK SYN & 6 F V f v
7 BEL ETB ' 7 G W g w
8 BS CAN ( 8 H X h x
9 HT EM ) 9 I Y i y
10 LF SUB * : J Z j z
11 VT ESC + ; K [ k {
12 FF IS4 , < L \ l |
13 CR IS3 - = M ] m }
14 SO IS2 . > N ^ n ~
15 SI IS1 / ? O _ o DEL
Transmitted
0 1 2 3 4 5 6 7
0 NUL DLE SP 0 @ P ` p
1 SOH DC1 ! 1 A Q a q
2 STX DC2 " 2 B R b r
3 ETX DC3 # 3 C S c s
4 EOT DC4 $ 4 D T d t
5 ENQ NAQ % 5 E U e u
6 ACK SYN & 6 F V f v
7 BEL ETB ' 7 G W g w
8 BS CAN ( 8 H X h x
9 HT EM ) 9 I Y i y
10 LF SUB * : J Z j z
11 VT ESC + ; K [ k {
12 FF IS4 , < L \ l |
13 CR IS3 - = M ] m }
14 SO IS2 . > N ^ n ~
15 SI IS1 / ? O _ o DEL
Control Sequences
Prefix Description Parameters
BEL Bell none
SO Switch to Alternate Character Set none
SI Switch to Standard Character Set none
Control Sequences
Prefix Description Parameters
F Device Operation Failed none
S Device Operation Succeeded none
U Device Operation Interrupted by User none

Parameters

Some control sequences take one or more parameters. While ANSI control sequences place the parameter between the control sequence inducer (ESC [) and the final character of the sequence, HP 2648A control sequences place parameters following the final character defining the command.

Each parameter consists of a digit sequence followed by a letter. For control sequences that take multiple parameters, all but the last parameter will have a lower case letter and the last parameter will have an upper case letter to terminate the parameter sequence.