Difference between revisions of "CodeChart:HP 2648A/HP 2648 Mode"
m (formatting) |
m (moved User:Legalize/Control Sequences/HP 2648A/HP 2648 Mode to CodeChart:HP 2648A/HP 2648 Mode: Promote to real code chart) |
||
(3 intermediate revisions by the same user not shown) | |||
Line 5: | Line 5: | ||
{{CodeChart | {{CodeChart | ||
| title=Received | | title=Received | ||
+ | | bel=#bel | ||
| so=#so | | so=#so | ||
| si=#si | | si=#si | ||
| esc=/ESC | | esc=/ESC | ||
}} | }} | ||
− | | style=" | + | | style="width: 2ex;" | |
| valign="top" | | | valign="top" | | ||
{{CodeChart | {{CodeChart | ||
Line 22: | Line 23: | ||
{| class="wikitable" | {| class="wikitable" | ||
|+ Control Sequences | |+ Control Sequences | ||
− | + | {{CodeDescriptionHeader}} | |
− | + | {{CodeDescriptionRow|BEL|bel|Bell}} | |
− | + | {{CodeDescriptionRow|SO|so|Switch to Alternate Character Set}} | |
− | {{ | + | {{CodeDescriptionRow|SI|si|Switch to Standard Character Set}} |
− | {{ | ||
|} | |} | ||
| | | | ||
Line 32: | Line 32: | ||
{| class="wikitable" | {| class="wikitable" | ||
|+ Control Sequences | |+ Control Sequences | ||
− | + | {{CodeDescriptionHeader}} | |
− | + | {{CodeDescriptionRow|F|f|Device Operation Failed}} | |
− | + | {{CodeDescriptionRow|S|s|Device Operation Succeeded}} | |
− | + | {{CodeDescriptionRow|U|u|Device Operation Interrupted by User}} | |
− | {{ | ||
− | {{ | ||
|} | |} | ||
|} | |} | ||
− | |||
== Parameters == | == Parameters == |
Latest revision as of 17:17, 15 February 2013
|
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|
Parameters
Some control sequences take one or more parameters. While ANSI control sequences place the parameter between the control sequence inducer (ESC [) and the final character of the sequence, HP 2648A control sequences place parameters following the final character defining the command.
Each parameter consists of a digit sequence followed by a letter. For control sequences that take multiple parameters, all but the last parameter will have a lower case letter and the last parameter will have an upper case letter to terminate the parameter sequence.